Wireless RF Transmitter and Receiver Module with HT12E & HT12DRF transmitter and receiver pair require this module for better communication and to avoid cross connection with other TX and RX pairs working at the same frequency. The RF Transmitter Module uses the HT12E IC for encoding the message and the RF Receiver Module uses the HT12D IC for decoding. 8 Pin DIP switch is used to set the address bit in the module. Features LED Indication 433MHz Frequency Range Range Upto 100Meter Address line selector switch

Part Number 1N5399 Peak Reverse Voltage 1000V AC Maximum RMS Voltage 700V AC Average Rectified Current 1

Compatible with most SFE designed USB boards as well as USB Arduino boards like the Uno

Polyester films provide high heat

These are Metal Film Resistor with a value of 680k ohm 2W and tolerance of ±5%

ensuring dependable operation

It has small size

Operating Voltage  3

These are Carbon Film Resistor with a value of 20k ohm 1/4W and tolerance of ±5%

the device is a great fit for both battery-powered systems and industrial Applications that undergo large line transients

Working Temperature Range (°C) €š¬‚¬œ 25°C to 60°C

The module is powered by a 12V DC source

Type Coin Cell  Model  CR2354 Nominal Voltage 3V Rated Capacity 560mAH Temperature Range  -30°C to 60 °C Diameter 23mm  Width  5