Plastics. Acquisition and presentation of comparable single-point data - Moulding materials1 Scope The ISO 10350 series identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. This document applies

Treatment plants

— this document is not applicable to spoken information or to signals comprising a sequence of impulses (such as a door finding signal)

lossless delivery of raw block data

6 Ensuring quality of examination results

The test method is applicable to all types of centrifugal pumps with a diameter over 50 mm operating under steady conditions

It does not apply to industrial kitchen sinks

BS EN 10088-2 on stainless steel offers the most up-to-date guidance on the classification of grades

wholesalers and retailers

Who is BS 4427-3 - Iron content in condensed phosphates for

25 Gbit/s and 10 Gbit/s VCSELs

3 of IEC 61508-4)

Why should you use BS EN 12697‑44- Crack propagation by semi-circular bending test