End mill holder Weldon with cooling channels HSK 63 - 32 - 110Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw and O ring All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

sleeves and tool arbors

Perforated plate for mounting accessories

- with clamping adapter Ø 6 mm und Ø 8 mm

Setting angle: 107

Especially in operations in toolmaking and mould making

E2= 20 pieces

Setting angle: 93°

Resolution: 0

From d = 25 on two clamping screws

For mounting straight-shank tools in 2 µm-collets

Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap

High flexibility: Large holding capacity up to –1 mm